Elaboración de un concreto f'c= 175 kg/cm2 con residuos de polvo de vidrio como reemplazo parcial del cemento y plástico triturado como reemplazo parcial del agregado grueso para la fabricación de un bloque de tabiquería de edificaciones multifamiliares en el distrito de San Juan de Lurigancho
Average rating
Cast your vote
You can rate an item by clicking the amount of stars they wish to award to this item.
When enough users have cast their vote on this item, the average rating will also be shown.
Star rating
Your vote was cast
Thank you for your feedback
Thank you for your feedback
Advisors
Eyzaguirre Acosta, Carlos AugustoIssue Date
24-09-03
Metadata
Show full item recordAdditional Links
https://audio.com/raupc/audio/14815Abstract
Esta investigación tiene como finalidad aprovechar los residuos de vidrio y plástico provenientes del distrito de San Juan de Lurigancho para utilizarlos en el sector de la construcción beneficiando a la ingeniería civil. Esta investigación se llevará a cabo utilizando polvo de vidrio y plástico triturado reemplazando al cemento y agregado grueso logrando un diseño de mezcla con una resistencia 175 kg/cm2 para elaborar bloques de concreto en muros no portantes. La primera parte consiste en una revisión bibliográfica donde se analizará la influencia de estos residuos en el concreto. Luego se ensayará el concreto con diferentes dosis de sustitución parcial de cemento por polvo de vidrio y agregado grueso por plástico triturado en 10%, 15% y 20%. Además, se elaborarán bloques de concreto con residuos de polvo de vidrio y plástico triturado con la dosificación más optima. Finalmente se compara las características técnicas, costo e impacto ambiental entre el bloque de concreto propuesto y el bloque de concreto convencional.This research aims to take advantage of glass and plastic waste from the San Juan de Lurigancho district to use it in the construction sector, benefiting civil engineering. This research will be carried out using crushed glass and plastic powder replacing cement and coarse aggregate, achieving a mix design with a resistance of 175 kg / cm2 to make concrete blocks in load-bearing walls. The first part consists of a bibliographic review where the influence of these residues on concrete will be analyzed. then the concrete will be tested with different doses of partial replacement of cement by glass powder and coarse aggregate by crushed plastic in 15%, 25% and 35%. In addition, concrete blocks will be made with glass powder residues and crushed plastic. Finally, the technical characteristics, cost and environmental impact between the proposed concrete block and the conventional concrete block are compared.
Type
info:eu-repo/semantics/bachelorThesisRights
info:eu-repo/semantics/openAccessLanguage
spaEmbedded videos
Collections